SP-WRC3.1 English

SWP-WRC3.1 STEERING WHEEL CAN SWITCH PANEL

SWP-WRC3.1 Membrane Steering Wheel Panel

Price: 1615 €
Special push button stickers: 80 €
Paddle shift option: 2499 €
all prices with VAT 24 %

Designed for Sabelt 320 ALU steering wheel. Steering wheel diameter 330 mm. Note! FIA regulation doesn't allow modification of steering wheel.

1 CAN line, 1 Mbit/s throughtput data rate, 2.0B protocol.
Selectable bus speed: 1 Mbit/s and 500, 250, 200, 125 and 100 kbit/s
Software selectable 120 Ω terminator
Protection against short circuit to ground and battery
1 Digital input for programming enable (ENCP)
Input resistance: 4.7 kΩ (5V pull-up)
Upto 12 Keyboard buttons with backlighting and with integrated 2 – color gauge LED. Button state transmitted on CAN.
4 Mechanical rotary switches. Mechanical endless with electrical „smart stop“ feature. Number of positions adjustable by SW.
2 On–Off drivers
High side driver Vbattery, up to 1 A
Output voltage reread
Linear current limitation
Overload, over temperature feedback and protection
Integrated in keyboard buttons. 2 color state (red – green). Activation received from CAN. Each LED controlled independently from button. LED color adjustable by SW within red – green scale. Brightness adjustable by SW. 2 Status Gauge LED groups at rotary switches.
Each LED group has its independent control – internally (by firmware) or via CAN. Position can be memorized at power off. LED colors can be modified on request (HW modification).
1 Internal temperature
Sampling resolution: 10 bits
Temperature range: -40 / +120 °C
2 High side switch outputs voltage reread
Voltage partition 20 mV
Analogue anti aliasing filter

Overall dimensions:

Without cable: 189 x 118 x 24 mm
Including rotary knobs: 189 x 118 x 39 mm
20 cm cable with ASL606-05PB connector,. Mating connector (ASL106-05SB) available separately. Coiled cord availabe separately.

Enclosure

Machined aluminum / ABS cover
IP grade: IP54
Weight (without steering wheel): approx 245 g

Panel mounting on steering wheel usually by cable ties

Layout - button positions are optimised to be easillyreachable with the thumb keeping the hand on handgrip.

Layout graphics is an integral part of the membrane applied by seriography. Special stickers by request.

Relief of buttons are heighten by applying silicone caps on the top of the buttons (height increase upto cca 1.5 mm)

Programable with Peak PCAN-USB interface cable

Specification

Link to web shop

​SO ENGINEERING

SO ENGINEERING